Barthmobile Portal
New Coach
05-27-2021, 01:23 PM
Duane88New Coach
So I bought SueWs' 88 Regal, having it shipped to Iowa. Not yet sure what the plan for it is yet. If my spouse likes it and agrees to travel in it, then it has found a new home. If not I will get it all in running order and flip it, either way it is a great summer project. A really nice coach deserves a new life for sure.
This Regal sure looks to be a lot nicer inside than Ole Nose, should be here in Iowa this weekend, perhaps if all goes well and it gets road worthy it will make the trip to Minnesnowta in two weeks rather than Nose.
1971 24 ft Barth Continental
P30 chassis
350 engine
So Duane I shouldn’t tell you about the 75 bustle in Clear Lake Iowa at $6500. It looks really nice.
The Coach you bought looks really nice. Hope it works out well. Tough waiting……..
Dana & Lynn
1997 38ft Monarch front entry
Spartan Mountain Master Chassis
Cummins 8.3 325hp
Allison MD-3060 6 speed
22.5 11R
Cummins Factory Exhaust Brake
8000 watt Quiet Diesel Generator
9608-M0022-38MI-4C
Christened Midnight
1972 22ft
72081169MC22C
Christened Camp Barth
05-27-2021, 07:34 PM
Steve VWCooll! New project. Always important to bring wife if possible. As my friend Jim Roller says, “she won’t drive the bus, so she gets to push!”
Or, “How do you install an AC? I need to explain to Joanie how to do it.”
Hoping you have a smooth transition.
9708-M0037-37MM-01
"98" Monarch 37
Spartan MM, 6 spd Allison
Cummins 8.3 325+ hp
05-27-2021, 09:48 PM
Duane88quote:
Originally posted by Dana:
So Duane I shouldn’t tell you about the 75 bustle in Clear Lake Iowa at $6500. It looks really nice.
The Coach you bought looks really nice. Hope it works out well. Tough waiting……..
Dana, no more Barths for me, you need another hunting, fishing camp!!!

1971 24 ft Barth Continental
P30 chassis
350 engine
That one looks like a cool well kept road worthy rig Only 6500 more than I would pay.
Dana & Lynn
1997 38ft Monarch front entry
Spartan Mountain Master Chassis
Cummins 8.3 325hp
Allison MD-3060 6 speed
22.5 11R
Cummins Factory Exhaust Brake
8000 watt Quiet Diesel Generator
9608-M0022-38MI-4C
Christened Midnight
1972 22ft
72081169MC22C
Christened Camp Barth
05-28-2021, 08:38 AM
Harold,Cat&SamCongratulations on the new project

Harold
Cat
Sam Miniature Schnauzer
3.8.2009 - 9.24.2021
93 30ft Breakaway
9209-3823-30BS-11B
KE5WCW
05-28-2021, 11:48 AM
Jim and TereDuane, I'm curious about how you're having it shipped. The guy from Denmark that bought my class c, had it shipped to the port on a car trailer. It was just barely low enough to fit under the bridges on the interstate. I think the cost from TN to MASS was about $1000.
Jim
 | |  |
|
|
1985 Regal 29' Chevy 454 P32 8411 3172 29FP3B Gear Vendor 6 Speed Tranny |
|
|
|
05-28-2021, 01:14 PM
Duane88quote:
Originally posted by Jim and Tere:
Duane, I'm curious about how you're having it shipped. The guy from Denmark that bought my class c, had it shipped to the port on a car trailer. It was just barely low enough to fit under the bridges on the interstate. I think the cost from TN to MASS was about $1000.
Jim
We measured the RV and with A/C it was just over 10foot and the trailer was less than 3 foot bed height, so it shipped without permits. not cheap was $1500 from Knoxville to Clinton.
1971 24 ft Barth Continental
P30 chassis
350 engine
Is it on its way Duane? Or is it there? I figure I may hear a few whoops if I go outside and it’s there!
Dana & Lynn
1997 38ft Monarch front entry
Spartan Mountain Master Chassis
Cummins 8.3 325hp
Allison MD-3060 6 speed
22.5 11R
Cummins Factory Exhaust Brake
8000 watt Quiet Diesel Generator
9608-M0022-38MI-4C
Christened Midnight
1972 22ft
72081169MC22C
Christened Camp Barth
05-28-2021, 05:01 PM
Duane88[QUOTE]Originally posted by Dana:
Is it on its way Duane? Or is it there? I figure I may hear a few whoops if I go outside and it’s there | |  |
|
|
1985 Regal 29' Chevy 454 P32 8411 3172 29FP3B Gear Vendor 6 Speed Tranny |
|
|
|
05-29-2021, 04:27 PM
Duane88Geez,, Jim Wine for two months would break me!!
So I got to look at the brakes today, pretty sure it was the master cylinder replaced it and I have some brake pedal (none before) but the system needs to be bled. However someone took a vice grip to bleed valves, rounded them off and they are so tight I can not get them to unscrew. Hope I do not need to buy calipers just because of this stupid valve.
Going over to Harbor Freight and see what I can find to grip and loosen them.
1971 24 ft Barth Continental
P30 chassis
350 engine
05-29-2021, 10:04 PM
Duane88So got a real sturdy pair of vice grips still no luck breaking the bleed valve free. Thought what can I lose, put the wheel back on and put the coach on the ground. To my delight there was great brake pedal. Started 88 up and tried to back up no luck brakes were frozen, shifted back and forth drive and reverse and they loosened up after a few minutes. Still probably will do a bleed but for now it seems ok. Backed it out of the driveway and turned it around and backed it in the driveway, the brakes seemed ok. Tomorrow will put some air in the tires and drive around town a bit, needs gas and what is in it now is 6 or 7 years old I guess,
Cool point, the master cylinder is from a 1980 P30, I got lucky and got a counterman at O'Reily That took the time to find a match to the master that I brought in, an initial check showed the one the book said I needed was different. Chevy must have been using up old inventory.
Took a closer look at the AIR pumps there are 2, one is completely disconnected, the other is still on the serpentine belt but the output is open to the atmosphere. The EGR valve is gone too. A/C compressor has no belt on it either.
The front air springs are disintegrated. Replaced them on Nose, what a pain. Think I will buy some coil over shocks and see if they work as well as they do on Nose before getting new air springs. Have not looked closely at the rear ones yet, but not much hope.
88 has an in-dash tack but it does not work.
Day one over!!
1971 24 ft Barth Continental
P30 chassis
350 engine