I have put together a list of wire numbers/terminal board numbers/etc. and sorted it in various ways. I have attached it. I don't know if it will be of any help. It may get some additional editing in the near future but I can post it again.

1993 Barth 38' Regency Wiring Pt1 - (26 KB) ~ Wire List for 1993 Regency

Your list is great! I have downloaded it but wonder if you can tell me where each of the TB's are and how to recognize them?
Thanks
Tom

Hey Lance - your wiring printout is great. Ours is a 1994 Breakaway, but should be similar. I have the same problem as Tom - nothing is marked or labeled and need to understand where the Terminal boards are and how to identify each one?
Richard Farr
richardfarr@cox.net

As the discussion has often indicated, no two are alike, but I had thought that the wiring in our 1993 Breakaway was just the standard.
Our wiring is ALL labeled and numbered--- am not sure if the numbering is from end to end of the wire, but in the electrical compartment all are numbered and labeled! !

Bud

Bud, my Breakaway is same as yours. All wires are white and each has a number and and ID as to what it is for. The labeling goes the full length of each wire. Most wires are very easy to trace along their path. I have some wires that I can not find the other end.

Example: I have a "trans temp" labeled wire at the instrument panel but the transmission has no temp sender. I even looked at the ECU for the transmission but found nothing.

Wrench is right-on. I have a 93 breakaway routing diagram, (not just sure where as I am in gv,az and the Barth is still in Ticaboo, Ut but will look for it and scan it. it is a little hard to follow but after a while you can even figure out where the "spare" wires are. will bookmark this page and be back in a few days, john