On the right side tank of my barth the line has a hole somewere need to replace it has anyone did this and how hard is it to do, not much room. Also my genset has a wire problem run but will not run the A/C or charge the battery. it is a 79 28 gas. thanks for all the help:

i replaced the gas lines that go from the tank to the gen set...it was a pain, but at least i shouldnt have to worry about it again..i ran the tank down to almost empy, then dropped the tank down a little at a time, untill i could fit my hands up over top of the tank...then by "feel" i pulled the old line off, and slid the new line on, then the hose clamps....all by feel....there is hardly any room, so it was frustrating, but patience prevailes.. it may even be easier to drop the tank all the way down in your case.

I have a saber saw, and I'm not afraid to use it. There will soon be a hole in the floor under the bed to allow access to the fuel pump, sender, lines, etc.

Metal plate over it, of course.

My A/C did not work when I first picked up my Barth. I hit the reset button on the side of my genset. The switch is a circuit breaker and it just pops back into place.

------------------
http://www.truckroadservice.com/